Site Information

 Loading... Please wait...
  • Call us on (800)-969-2219
  • My Account
  • Gift Certificates

Blog

Modular Fixture Systems

Modular FixturesModular fixtures are ideal for temporary fastening. You can use all of the modular components for occasional jobs, or short runs or prototypes. It is also used for testing fixtures to see if they’ll have an adequate performance of the design.The components are available in standard and heavy sizes. The plates and blocks have holes at regular distances. You can use [...]

Read More »


How to deburr your sheet metal edges

Without a doubt, you need to remove burrs from your sheet metal edges. When you have smooth edges on your metal sheets, you’ll be able to manipulate them in a safer manner. By removing the edge burrs we reduce the chance of someone getting hurt.We can remove our sharp edges with a manual deburring tool, [...]

Read More »


Why do carbide end mills break or wear out?

Why do carbide end mills break or wear out?When speaking with most our customers, they request to solve one or two problems with their end mills. They either break the cutting edge on their tool or the edge wears out prematurely.Up next we’ll show you 8 causes of this 2 problems and their possible solutions.Breakage:Wear:

Read More »


​Toggle Clamps: Holding capacity & clamping force

Toggle Clamps: Holding capacity & clamping forceToggle clamps have specifications in terms of holding capacity and clamping force. It’s important to distinguish the difference between these two concepts and to know how they are measured in order to make the best decision when choosing clamps for each application. [...]

Read More »


High Speed Steel vs Carbide

Just like High Speed Steel replaced Carbon Steel, Carbide is now being used more and more for end mills and drill bits. Even so, HSS blades and drill bits are used in certain important niches for metal cutting applications. There are many ways to make HSS cutting tools efficient and economical without sacrificing cutting speeds, [...]

Read More »


​Why is aluminum difficult to machine.

Why is aluminum difficult to machine. We know that machining aluminum is not as simple as it seems. There are many grades and for each one there are different machining techniques that can be applied. To begin we will review the different grades of aluminum and from this we will give some recommendations of types of [...]

Read More »


How fast can you produce a thread?

How fast can you produce a thread?The quality of the thread and the performance of the tap will be affected by the RPM we used while making the thread. RPM is a function of perimeter speed (typically in meters or feet per minute). Most tapping suppliers have their tables to convert the perimeter speed to RPM.The optimum speed to produce a [...]

Read More »


You’ve got problems with your carbide drill bits?

Do you have the following problems with your carbide drill bits: Wear on the outer edges, chipping of the cutting edge or tip, tool breaking? In this article we will mention the causes of most of the problems that may occur with your drill bits. To clarify, in this article we’ll be focusing on work pieces made of metals, [...]

Read More »


Do you want to extend the life of your end mills?

The premature wear of your end mills is an added cost to your company but also it affects your productivity. Any talk of milling should start with the feed and speed of cut. This two variables are going to define what’s next.Feed & Cutting SpeedWith the feeding & cutting speeds, we determine the chip-break. For [...]

Read More »


Do your pin fixtures wear out prematurely?

If your locating pins on your fixtures wear out too quickly then we have a solution for you. With a PVD coating which is hard, abrasion resistant, and slippery, resulting in a component that has a longer lifecycle for high-production applications. This extended lifecycle allows these items to remain in production longer with less need [...]

Read More »